📋 Tender Overview
The Ministry of Transport Mobility and Urban Agenda Mitma has approved a Ministerial Order to further specify the application of the comparative method in the design and manufacture of the new metric gauge trains for the network of Asturias and Cantabria. The method is included in the European standard EN 15273 and although its use in Spain was already compatible with the current Order FOM 16302015 of July 14 which approves the Railway instruction of gauges IFG the Ministry has decided to explicitly include the reference to said European standard.Thus through the OM published today in the BOE at the proposal of the State Railway Safety Agency AESF the text of the IFG is modified to include that in lines where it is not possible to comply with the limit gauge of implementation of the GEE10GED10 obstacles the regulation established by the UNE-EN 15273-1 and UNE EN 15273-2 standards may be used to design the constructive profile of new trains. by comparison with trains that demonstrate extensive commercial experience on the corresponding section of track.At this point it should be noted that the Spanish standard already states that the constructive profile of the vehicle will be determined in such a way as to guarantee non-interference with obstacles and in no case may it rush the maximum constructive profile of the GEE10 gauge calculated in accordance with the defined methodology.Although it is not considered essential the Ministry has chosen to advance this reference explicitly to specify and detail the application of the comparative method. The AESF had already planned to incorporate the content of the EN-15273 standard in a next revision of the IFG when the new version of the aforementioned European standard currently in the process of approval had been published which will detail more application of the comparative method.The methodThe comparative method which has given good results in other countries such as the United Kingdom consists of designing the section of the new trains from the section of the trains that currently run on the network. This method will optimize the design and use of the cross section available in the metric gauge network.In this context it should be remembered that no train has been manufactured since the inconsistencies were detected in the early stages of the design of the new units and that no euro of the Spanish has been wasted. The search and approval of the optimal solution to design the widest most modern fast and efficient trains possible and adapted to the unique railway infrastructure of Cantabria and Asturias has not involved the waste of public resources.This reflection is what has avoided a greater evil that is that the trains had been manufactured and that they were smaller which would not meet the expectations of users.The Railway Infrastructure Instructions IFI and Energy IFEThis order also serves to approve the Railway Instruction for the design and construction of the Infrastructure subsystem IFI and Railway Instruction for the design and construction of the Energy Subsystem IFE.These Railway Instructions have been developed under article 68.2 of Law 382015 of September 29 on the Railway Sector which establishes that by Ministerial Order at the proposal of the State Railway Safety Agency the technical conditions on the design and construction of railway infrastructures will be established.According to article 76 of Royal Decree 9292020 of October 27 on railway operational safety and interoperability Mitma may approve Railway Instructions FI that must be complied with by all subsystems and their components to obtain the corresponding authorizations for entry into service.These are technical standards of great relevance since they include those technical specifications that must be met by the fixed infrastructures of the lines and their power supply systems together with the European Interoperability Technical Specifications standards to allow their commissioning and that they must maintain throughout their useful life.Each of these FIs is arranged in two distinct parts on the one hand those requirements that are considered to be national rules notified within the scope of Directive 2016797 and that cover national singularities or open points of the TSIs are included and on the other hand other additional instructions are included that are convenient to ensure a good design and construction of these subsystems without implying any kind of obstacle to interoperability.